Tag Archives: milking cycle

297-306 P. Vaculik, M. Prikryl, J. Bradna and L. Libich
Energy consumption of milking pump controlled by frequency convertor during milking cycle
Abstract |
Full text PDF (514 KB)

Energy consumption of milking pump controlled by frequency convertor during milking cycle

P. Vaculik*, M. Prikryl, J. Bradna and L. Libich

Czech University of Life Sciences Prague, Faculty of Engineering, Department of Technological Equipment of Buildings, Kamýcká 129, CZ165 21 Prague 6 – Suchdol, Czech Republic
*Correspondence: vaculik@tf.czu.cz

Abstract:

The article deals with selected parameters affecting the energy consumption of a vacuum pump in a milking system during the whole milking cycle in variants with and without regulation by a frequency convertor. When put into practice, the latest research of creation, control and stabilization of vacuum in milking devices allows dairy farmers to obtain a vacuum system that ensures maximum stability of milking pressure, which is a basic requirement affecting the health of dairy cows. The choice of vacuum system prioritizes in particular high performance, maximum operational reliability, minimum maintenance, long service life, environmental friendliness and economy. The vacuum pump was a Roots vacuum pump with a rotary piston which is typical for this use. Use of a frequency convertor significantly affected the efficiency of this pump for control of vacuum pressure level and pump performance by varying the rotation frequency according to the actual airflow requirement. Using this control system, only as much vacuum pressure is produced as necessary. By measurement of an experimental setup, it was found that the average power requirement of a setup with a control valve was 3.8 kW compared to 1.7 kW in the case of the variant with frequency convertor. Measurements and calculations have shown that this system is capable of saving more than 50% of electric energy.

Key words:

, , , ,