Tag Archives: solid fuel

xxx D. Urbancl, J. Krope and D. Goričanec
Torrefaction – the process for biofuels production by using different biomasses
Abstract |
Full text PDF (518 KB)

Torrefaction – the process for biofuels production by using different biomasses

D. Urbancl*, J. Krope and D. Goričanec

University of Maribor, Faculty of Chemistry and Chemical Engineering, Smetanova street 17, SI2000 Maribor, Slovenia
*Correspondence: danijela.urbancl@um.si

Abstract:

Torrefaction process is a mild pyrolysis, where biomass material is converted into solid fuel with higher heating value. The results of torrefaction at different temperatures in a range from 220 to 400 °C for three varied materials, oak wood, mixed wood and dehydrated, granulated sewage sludge are presented. The torrefaction process started with warm up stage, which took place for 30 minutes, after that sample was torrefied for 2 hours at constant temperature. The process continued with cool down stage. The energy demands were covered by electric power, while the flue gasses were not integrated in the process. The influence of the operating temperatures are analysed in order to determine optimal operation parameters to get the torrefied biomass with highest calorific value. Furthermore, the optimal operation time according to the largest increase in calorific value for each material is evaluated. The results of calorific value, mass drop and chemical compositions such as elemental analyses are also presented. Results show that heating values increase with raising temperature for both wood samples. The heating values for sewage sludge increases to approximately 320 °C, after that temperature are unchangeable. Torrefied oak wood samples were more fragile at higher temperatures in comparison to raw or torrefied oak wood samples at lower temperatures. At torrefied sewage sludge samples the changes in fragility are not detected due to pre-prepared granulates of sludge.

Key words:

, , , , ,