Tag Archives: system ‘push-pull’

1950-1959 V. Bulgakov, S. Ivanovs, M. Arak, V. Kuvachоv, L. Shymko and V. Bandura
Experimental investigation of the work of a ploughing aggregate, operating according to the system ‘push-pull’
Abstract |
Full text PDF (730 KB)

Experimental investigation of the work of a ploughing aggregate, operating according to the system ‘push-pull’

V. Bulgakov¹, S. Ivanovs²*, M. Arak³, V. Kuvachоv⁴, L. Shymko¹ and V. Bandura⁵

¹National University of Life and Environmental Sciences of Ukraine, Heroiv Obrony street 15, UA03041 Kyiv, Ukraine
²Latvia University of Life Sciences and Technologies, Liela street 2, LV-3001 Jelgava, Latvia
³Estonian University of Life Sciences, Institute of Technology, Kreutzwaldi 56, EE51006 Tartu, Estonia
⁴State Agrotechnological University, 18 B. Khmelnytsky Ave, UA72310 Melitopol, Zaporizhia obl., Ukraine
⁵Vinnytsia National Agrarian University, Soniachna street 3, UA21008 Vinnytsia, Ukraine
*Correspondence: semjons@apollo.lv


The use of ploughing machine-and-tractor aggregates, operating according to the principle of ‘push-pull’, finds increasing application in the world since it allows ensuring the stability of the movement and the depth of ploughing, reduction of the energy indicators. The aim of this experimental study is to determine under field conditions the dynamic and operational technological parameters of the ploughing machine-and-tractor aggregate, operating according to the ‘push-pull’ system. This aggregate was an integral ploughing-tillage wheeled HTZ 16131 tractor, in front of which there was mounted a two-bottom plough, and at the rear – four-bottom ploughs. This aggregate has satisfactory path parameters of the movement during the execution of the technological process of ploughing. The oscillations of the furrow path for this aggregate are of a low-frequency nature and are concentrated in a rather narrow frequency range (0…50 m-1). At the operating speed of 2.0 m∙s-1 it is 0…0.16 Hz. The maximum value of the mutual correlation function between the input impact (the turning angle of the driven wheels of the aggregating tractor) and the output value – its relative bearing is positive and reaches a value of 0.88. Stability of the ploughing depth for the aggregate according to the ‘2 + 4’ scheme is ± 1.65 cm2, which is normally the smaller value of the same indicator for a serial ploughing aggregate (± 1.98 cm2).

Key words:

, , ,