Tag Archives: discrete element methods

519-530 B. Černilová, J. Kuře, M. Linda and R. Chotěborský
Tracing of the rapeseed movement by using the contrast point tracking method for DEM model verification
Abstract |
Full text PDF (922 KB)

Tracing of the rapeseed movement by using the contrast point tracking method for DEM model verification

B. Černilová¹*, J. Kuře¹, M. Linda¹ and R. Chotěborský²

¹Czech University of Life Sciences Prague, Faculty of Engineering, Department of Electrical Engineering and Automation, Kamýcká 129, CZ165 21 Prague – Suchdol, Czech Republic
²Czech University of Life Science Prague, Faculty of Engineering, Department of Material Science and Manufacturing Technology, Kamýcká 129, CZ165 21 Prague – Suchdol, Czech Republic.
*Correspondence: cernilova@tf.czu.cz

Abstract:

For designing the efficient storage and transport of rapeseed, it is necessary to follow the rules of bulk material, know its properties, and use appropriate equipment. The mentioned properties of bulk material are essential for simulating the numerical model and obtaining the parameters of the geometry particle tracing during the rapeseed manipulation. In order to determine the angle of repose and mechanical properties of rapeseed, the results of previous experiments were used. The aim of this paper was to propose the methodology for calculating the traces of individual particles using the contrast point method during a real test to calibrate and verify a numerical model of the same system as in a real test. RockyDEM software was used to create the numerical model of rapeseed. The numerical model was used to test the flow analysis of rapeseed particles. The experiment measuring rapeseed particle traces was performed using an assembled experimental device. The rapeseed particles and the contrast point particles were poured out from the device, and a camera recorded the process. In parallel with the real experiment, the angle of repose test was performed on the same device to verify the numerical model. The results showed that the methodology is suitable for the DEM model verification with an accuracy of 3.77 mm in the X-axis, 0.55 mm in the Y-axis and 1.7 mm in the Z-axis. This confirmed that the proposed method is suitable for determining the surface behaviour of bulk material to verify the DEM model.

Key words:

, , , ,




551–558 J. Kuře, L. Hájková, M. Hromasová, R. Chotěborský and M. Linda
Discrete element simulation of rapeseed shear test
Abstract |

Discrete element simulation of rapeseed shear test

J. Kuře¹*, L. Hájková², M. Hromasová², R. Chotěborský¹ and M. Linda²

¹Department of Material Science and Manufacturing Technology Faculty of Engineering, Czech University of Life Sciences Prague, Kamýcká 129, CZ165 21 Prague – Suchdol, Czech Republic
²Department of Electrical Engineering and Automation, Faculty of Engineering, Czech University of Life Sciences Prague, Kamýcká 129, CZ165 21 Prague – Suchdol, Czech Republic
*Correspondence: kure@tf.czu.cz

Abstract:

Suitable equipment are required for storage and transportation of rapeseed which are developed according to rules for bulk matters. It is one of reasons where bulk matter properties are important to the design. Bulk matter properties are important to known as angle of repose, internal friction, external friction, adhesivity force and other bulk properties. Experimental values of bulk properties are added to mathematical models. The model should be calibrated with adequate experiment. The shear test is one of popular calibration test for bulk matters so that be able done experiment and numerical model in one. The aim of this paper is simulation of rapeseed bulk properties during shear strain and flow and its evaluation and calibration with experimental tests. RockyDEM software was used for numerical simulation of rapeseed. Shear test, angle of repose, static and dynamic friction test were used to calibration of the numerical rapeseed model. Sensitivity of numerical model is discussed on the bulk properties.

Key words:

, , ,